Top Page > Browsing
What are the operational problems of the 4 1/2 super thin cutting disc?
Date: 2018/11/12 11:53
Name: yang huimin   <>

4 1/2 super thin cutting disc must pay attention to some operational problems when used, in order to better use and better cut materials. The following are some operational problems that need to be paid attention to during use:
front operation problem: For daily use, many operators are always used to operate on the cutting piece. The reason for this direction is that the force can be used. In fact, the behavior of the grinder should be specifically prohibited. According to the operating procedure, when grinding the workpiece with a grinder, the operator should stand on the side of the cutting wheel of the grinding wheel and do not operate it on the front side to avoid the failure of the grinding wheel to fly out or break up and hurt people.
force operation problem: When the grinder is used, some operators, especially young operators, are trying to make the grinding speed fast and the force is too strong, which is a very unsafe operation behavior. Any grinding wheel cutting piece has a certain strength, which is likely to cause the resin grinding wheel cutting piece to break, and even fly out to hurt people, it is also a prohibited behavior.
Page: [1]

Thread Title (must) Move the thread to the top
Your Name (must)
E-Mail (must)
Password (used in modification of the submitted text)
Comment (must)

   Save Cookie